How to Diagnose and Reset BMW PDC Parking Warning. You need a YOUCANIC Full System scanner [1] to diagnose the BMW parking assistance system. Locate the OBD-II port under the dashboard on the driverโs side. Plug your scanner and turn on the ignition. Allow the scanner to turn on and select your BMW model. Select Control Units from the main menu.
I remember my F10 (when we had it) would prompt a replace battery message in the car when the FOB battery needed replacement. Sometimes the simplest answer might be the correct one. Your new battery will need registration, which an indy should be able to do, but before you get caught up in that, try replacing the battery in your key fob and see In F10, the PDC control unit is integrated into the JBE. As you describe a global power problem with the sensors, I would start looking at the JBE. There exists an 18pin connector which connects to the actual sensors. Check if it is sitted correctly. Pin 1 (yellow) gets power (with ignition on) to the front sensors and pin 6 (yellow) to the rear. 2Vnf4D. 120 284 75 339 435 399 207 426 387